Akwscyby EB-001-3 Outdoor Electrical Box Review

The Akwscyby EB-001-3 is a wall- or pole-mount weatherproof electrical enclosure in galvanized steel, with a reinforced aluminum rear beam, a hinged door and a top-cover vent that carries a built-in mesh panel. The kit includes a thermostat, a cooling fan, a 12V/1A power supply, sealing strips and a dust mesh.

It is not a server rack or a network cabinet. There are no 19-inch or 10-inch rails, no U-height and no rack-mount ears. The aluminum rear beam is a mounting surface for gear, not a rail. For a home lab or a small office, treat it as an outdoor or edge enclosure: the box you put a router, an ONT, a mesh node, an access point or a DIN-rail switch in when the gear lives outside the building.

The steel is galvanized and finished with a double-layer electrostatic powder coat applied in a single pass, and the rear beam is reinforced aluminum. Buyers on Amazon most often praise the sturdiness of the box and describe mounting and installation as straightforward.

Sealing comes from strips on the door and on the guide groove, a dustproof mesh inside, and the mesh panel in the top vent. The box is rated IP65, which means dust-tight and protected against low-pressure water jets. It is not a submersion rating, and it says nothing about corrosion resistance.

The rating applies to the box as built. Drilling for cable glands, adding a vent or pinching the door gasket changes it. Mount the box under an eave or in shade where you can: the top vent is shaped to shed rainwater.

The included fan exhausts through the top vent while air is drawn in through the side and bottom mesh. The automatic temperature controller has a digital display and switches the fan on and off at your setpoint, with 0.1°F resolution over a wide range.

What the fan can and cannot do

It is a single exhaust fan, not air conditioning. It moves air and slows heat buildup, but it will not hold a heavily loaded PoE switch near ambient in a hot, sun-exposed spot. Oversizing the box and shading it matter as much as the fan.

Setpoints to start from

Fan on around 90 to 95°F and off around 80°F are reasonable starting points. Place the probe where the gear actually sits.

Heating and condensation

There is no heater or dehumidifier in the box. The thermostat controls the fan only, and the enclosure is listed as compatible with a heating and dehumidification unit sold separately.

The external dimensions are 17.7" H × 13.4" W × 9.0" D. Inside, you get 15.7" H × 11.8" W × 7.9" D (≈24 L). The walls, door, rear beam, fan and thermostat all take room, so plan around the internal figures.

A small router, ONT, mesh node or access point fits comfortably, and one buyer on Amazon reports fitting a DIN-rail-mounted 8-port network switch. A compact NVR, a 12V adapter and a modest cable bundle with room for its bend radius also fit. 19-inch rack equipment, deep 1U switches and large multi-bay NVRs do not.

Mount the box on a wall or a pole using the rear beam. Run cables through glands or grommets sized to the cable, enter from the bottom and form a drip loop so water cannot track in. Seal any unused openings.

The 12V/1A adapter needs a protected outlet, either inside the box or fed through a gland from outside. Bond the steel door and backplate to ground, as with any metal enclosure. After any drilling, re-check the door gasket and the vent mesh.

It fits home-lab and small-office users putting network gear in a garage, shed or outbuilding, or on an exterior wall, and anyone who wants a lockable, weather-resistant steel box with managed airflow included. It does not fit anyone expecting a rack, anyone needing built-in heating, or anyone cooling high-wattage gear in direct sun.