Jingchengmei MFT-VW04UBB Vertical Wall-Mount Rack Review

The MFT-VW04UBB is a 19-inch, 1U open vertical wall-mount rack bracket in cold-rolled steel with a black finish, sold by Jingchengmei under manufacturer part number JCM-VWRF. It is an open bracket, not an enclosure: no door, no side panels, no lock and no dust protection. Your equipment stays exposed, which is fine in a closet or under a desk and wrong for a public or dusty room.

It mounts vertically on a wall or horizontally under a desk or table. The bracket is listed as compatible with standard 19-inch rack-mountable networking and server equipment: network switches, routers, firewalls, patch panels and coax termination, network hubs and modems. It arrives ready to mount, so the bracket itself needs no assembly.

The bracket is 19.29 inches wide, 2.3 inches deep and 3.54 inches high, and its maximum load capacity is 35 lb. It is a rack-mount bracket with 1U of rack space.

One rack unit is 1.75 inches, so 1U is room for a single 1U device, such as one switch or one patch panel. The 19 inches is the nominal panel width; the mounting holes sit inside that, which is why standard 19-inch gear lines up.

Buyers on Amazon most often praise how solid the bracket feels for its size, and sturdiness comes up repeatedly as a positive point. The mounting flexibility is the feature they call out most: it works as a 1U-against-the-wall or under-table mount, which is exactly the awkward spot most small setups have.

The hardware kit for the gear is in the box. Cage screws and nuts for mounting equipment are included, and buyers consistently mention the kit being complete for that job. Because it is a standard 19-inch, 1U bracket, a 1U switch, router, firewall, patch panel or modem drops in without adapters.

The open design helps airflow and access. Nothing traps heat, and every port and cable stays reachable. The open steel bracket, the included cage hardware and the dual mounting are what justify the cost for a light install.

35 lb is the ceiling. That is fine for a switch, patch panel, router, firewall or modem; it is not a bracket for a rack server or a rack UPS. This is the single most important limit to check against your gear.

1U is tight. One 1U device is the maximum, so pick the piece of gear that matters most before mounting. The open bracket has no door, no lock, no dust or splash protection and no noise containment, and your equipment is visible and accessible to anyone in the room. There is no built-in cable management either, so cables hang free and you will want Velcro and a tidy drop.

The wall fasteners supplied are for a wood wall or drywall. Check what your wall is before you start, and confirm the bracket's hole spacing against your studs or mounting points before drilling. Vertical orientation also changes how gear sits: devices face up or down rather than flat, which is normal for vertical racks but worth knowing before you plan port access.

The box includes screws for mounting the bracket on a wood wall or drywall.

The 35 lb rating is the load the bracket is rated for, so keep the mounted gear well inside it.

Cage nuts and screws for the equipment are included.